エナメルXF-1をエナメルシンナーで1:10程度に薄めスミイレ Wash painted parts with thin (1:10) enamel XF-1. It accents part details. |
|
大胆にのせる Don't worry about over dose doing it!!. |
|
エナメルシンナーを含ませた綿棒でふき取るといい感じの使用感が出る Remove excess enamel by rubbing cotton swab with enamel thinner. Now you get nice natural look. |
|
白でペイントした前脚にも同じようにエナメルウォッシング Use same technique for the white sprayed landing gear struts. |
|
エナメルをふき取り、ライト内部をメタルカラーのクロームでペイント、乾燥後、綿棒でこするといい感じの金属感がでる After applying wash, paint Gunze's metal color chrome for the reflector of lights. It becomes a nice metal surface by buffing with cotton swab after paint dries. |
|
ペイントの間に先の準備。しっかりと接着するには洗濯ばさみが一番 While paint is drying, prepare next step. Rubber bands and clothes pegs are good for holding parts until completely glued. |
|
金属部品にはグンゼのサーフェサー1000を缶スプレー Spray Gunze's 1000 Surfacer for the undercoat of metallic parts |
|
エアースプレイによる金属ペイントはこれしかない!アルクラッド2は完璧な仕上がりだ。10分の乾燥後、マスキングテープもエナメルウォッシングも問題なし(クロームとポリッシュドアルミだけは例外、下地と乾燥後の取り扱いには注意が必要)。 エンジン部品にはJet Exhaustが合う。 Alclad II is complete solution for metal spraying. You can apply mask tapes and enamel washes over it only after 10 minutes (Chrome and Polished Aluminum are a different story. They need different undercoating and no touch policy). I use "Jet Exhaust" for engine fins |
|
バフXF-57とグレイXF-24をハンドペイント Paint buff XF-57 and neutral gray XF-24 for engine nozzle. |
|
エナメルウォッシング Enamel wash. |
|
出来上がり Finished |